Cross flow fan, also known as local ventilation fan, is a commonly used fan in industrial and mining enterprises. Unlike ordinary fans, its motor and blades are all in a cylinder, with a cylindrical shape. It is used for local ventilation and is easy to install. The ventilation effect is obvious and safe, and it can be connected to the air duct to deliver the air to the designated area.
Dry Type Transformer fan is designed and produced in strict accordance with JB/T8971-1999 Cross flow Cooling Fans for Dry type Transformers. The iron core of motor stator and rotor is made of high-quality cold-rolled silicon steel sheet; Low noise bearing; The impeller adopts aluminum alloy surface electrophoresis treatment, and then fine dynamic balance adjustment; The left and right end plates are made of stainless steel by stamping, and the air inlet plate, air outlet plate and air guide plate are made of aluminum alloy profiles by buckle combination; The whole fan has reasonable structure, beautiful appearance, large air volume, low noise, low temperature rise, long service life, stable operation, convenient installation, etc.
working principle When the cooling fan is used for the dry-type transformer, it is placed on both sides of the lower part of the transformer coil to blow the cold air directly into the high and low voltage cooling air ducts of the transformer coil, with obvious heat dissipation effect, which can ensure the normal operation of the transformer and extend its service life. (The functions such as fan startup and shutdown, transformer overtemperature alarm and overtemperature trip are provided by temperature control device). Model description For example, the fan model is GFDD470-120A, which means that the working voltage is single-phase 220V, the total length of the fan is 470mm, and the impeller diameter is 120mm. The top blowing dry-type transformer with the motor installed on the right side uses the Cross Flow Cooling Fan. Cooling mode The cooling mode of dry-type transformer is divided into natural air cooling (AN) and forced air cooling (AF). In case of natural air cooling, the transformer can operate continuously for a long time under rated capacity. In case of forced air cooling, the output capacity of transformer can be increased by 50%. It is applicable to intermittent overload operation or emergency overload operation; Due to the large increase of load loss and impedance voltage during overload, it is in a non economic operation state, so it should not be in a long-term continuous overload operation.
Henan New Electric Power Co., Ltd deals in the R&D, manufacturing and sales of various medium, high and Low Voltage Transformers and Transformer Accessories. The transformer accessories mainly include Buchholz Relay, Tap Changer , oil level gauge, butterfly valve, Moisture Absorber, pressure reducing valve, cross flow cooling fan, Bimetal Thermometer, Epoxy Resin Insulator, etc.Dry type transformer fan refers to the device used for transformer cooling. New and old customers are welcome to purchase and customize.